Our Z-Wave smart floodlight sensor reports back to your smart home hub when motion is sensed and when dusk or dawn happens. HomeSeer HS-FLS100+ Z-Wave Smart Floodlight Sensor | HomeSeer But the motion sensor at each light can also turn its specific light on when motion is detected. (Or use the smart switch cover over the existing dumb switch) That switch will turn all the lights on or off at the same time. So you put a smart switch indoors that does not control the circuit. Homeseer now makes an outdoor zwave motion sensor to retrofit dumb motion sensor lights. I think this is the one you were imagining. If you want any motion sensor to turn on all of the lights, then you just use a smart switch and use each motion sensor to trigger the same switch.ģ) One smart switch inside, one smart motion sensor light at each position outdoors In this set up, if you only want a motion sensor to turn on some of the lights, you don’t worry about the switch in doors: you put smart bulbs in the lighting fixtures and that way you can use any motion sensor to trigger any combination of the smart bulbs. The Zooz has an official integration with smartthings. There are now two made for outdoors, the hue outdoor motion sensor which is zigbee and Zooz outdoor motion sensor which is Z wave. I think the option most people use is to put up a separate outdoor motion sensor. So I would take a step back and look for models of dumb motion sensor lights that let you add an optional light switch. But it’s going to get complicated, and many motion sensor lights just don’t have a way to do this. Then the smart switch doesn’t even have to be on the same circuit branch. You may be able to put a smart relay in line between the motion sensor and the light, and once you have that, you can then have another smart switch that would trigger that smart relay. If the motion sensor light does not already provide wiring to add a switch, it gets more complicated. The trick of it is obviously that you don’t want to cut power to the motion sensor when you turn the light off from the switch or the motion sensor trigger won’t work until you turn the switch on again. You can definitely put in a smart switch to replace the potential dump switch and everything should work fine. If you get one like that, you are all set. There are motion sensor floodlights which have wiring that allow you to add a switch. First rule of home automation: “the model number matters.“ That applies even to the relatively dumb devices like A dumb motion sensor floodlight.īasically you have three options here, but the wiring can get tricky.ġ) dumb outdoor motion sensor floodlights, smart indoor switch. It’s going to depend on the specific wiring of the floodlight.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |